TribeCreek Subscribe on YouTube

Home › Farmall & International Harvester › Farmall (1932–1953)

Farmall F-12 (1932–1938) and F-14 (1938–1939): Telling Them Apart and Dating One

Updated November 21, 2026 · Sources are linked in the text

The little Farmall on narrow tricycle wheels at the auction is listed as an F-12. Or an F-14. Or "F-12/F-14," which usually means the seller isn't sure either. The two look almost the same from ten feet away, and parts have been swapped between them for decades. Which one you have decides what the engine should be rated at, which parts fit, and what the tractor is worth to a collector.

This page covers what changed between the F-12 and the F-14, the early Waukesha engine question, where the serial number is on each and how to date it, and what to check before you buy.

Video: Farmall F-12 Tractor (1932–1938): History & Specs (3:15) · Watch on YouTube

The small Farmall

The F-12 was International Harvester's small row-crop Farmall, built from 1932 to 1938. Tractor Data lists 123,442 built in the United States plus 2,848 at IH's plant in Neuss, Germany, along with a standard-tread version sold as the McCormick-Deering W-12 (Tractor Data).

The F-14 replaced it in 1938 and was built only into 1939, when the styled Farmall A and B took over the small end of the line (Wikipedia). Tractor Data gives 27,401 F-14s, a figure Farm Collector also quotes from the Hot Line Antique Tractor Guide. Wikipedia says about 32,000, and the F-14 serial range below spans about 31,900 numbers, so treat the production count as uncertain.

Engine4-cylinder, 113 cu in (3 x 4 in bore and stroke); IH overhead-valve engine, with a Waukesha engine on early F-12s
Rated speedF-12: 1,400 rpm. F-14: 1,650 rpm
FuelGasoline, or kerosene/distillate started on gasoline from a small auxiliary tank
Transmission3 forward, 1 reverse (German-built F-12-G4: 4 forward)
PTORear PTO, 1-1/8 in shaft (F-12)
StartingHand crank (F-14)
WeightAbout 2,700 lb (both)
Nebraska testsF-12: test 212, gasoline, May 1933, 16.20 belt hp, 12.31 drawbar hp; test 220, kerosene, Nov. 1933, 14.59 belt, 11.81 drawbar. F-14: test 297, distillate, April 1938, 17.44 belt, 14.84 drawbar
BuiltF-12 1932–1938 (Chicago), 123,442 US-built; F-14 1938–1939 (Chicago and Rock Island), 27,401 per Tractor Data

Engine, transmission, weight, PTO and test figures are from Tractor Data's F-12 engine, F-12 test, F-14, F-14 engine and F-14 test pages. The original reports are in the University of Nebraska archive: test 212, test 220 and test 297. The auxiliary starting tank is from Tractor Data's F-14 listing and Farm Collector's F-14 profile.

How to tell an F-12 from an F-14

Farm Collector, citing Lee Klancher's International Harvester Photographic History, sums up the change: the F-14 used the F-12's engine turned up from 1,400 to 1,650 rpm, with the gearing adjusted so both tractors have the same travel speeds. The F-14 also has a higher seat and steering wheel and a heavier seat spring, and the clutch and hand brake levers were moved to suit the new seating position.

What that means in the field:

  • Steering wheel and seat height. The F-14's wheel and seat sit higher. It's the most visible difference, but steering and seat parts unbolt, so treat it as a clue, not proof.
  • Lever positions. The clutch and brake levers on an F-14 are placed for the raised seat.
  • Governed speed. With a tachometer on a warm engine, an F-14 governs near 1,650 rpm and an F-12 near 1,400. A worn or adjusted governor can blur this.
  • Serial plate location and number. This is what settles it (next section).

The Waukesha engine question

Early F-12s didn't use an IH engine. Tractor Data lists a Waukesha 113 cu in four as the "original engine, used on early models," later replaced by IH's own 113 cu in overhead-valve four. Wikipedia says the same of early W-12s, the standard-tread version. Gas Engine Magazine profiles a Waukesha-engined 1933 F-12, serial FS-530, which its owner counts as the thirtieth F-12 built.

Exactly where the Waukesha run ended is less certain. Collector accounts give different cutoff numbers, and they don't agree. If you're looking at an early F-12, identify the engine itself rather than trusting a seller's serial cutoff. They're different engines from different makers, so confirm which one you have before ordering parts.

Finding and dating the serial number

Tractor Data gives different plate locations for the two models:

  • F-12: a serial plate ahead of the gear shift, below the steering column.
  • F-14: below the front end of the fuel tank, above the clutch housing.

Both use an FS prefix. The F-14's numbers start at FS124000, just past the last F-12 (123942).

Tractor Data's starting numbers by year:

  • F-12 (Chicago): 1932: 501. 1933: 526. 1934: 4881. 1935: 17411. 1936: 48660. 1937: 81837. 1938: 117518. Final: 123942.
  • F-12 (Neuss, Germany): 1938: NT101.
  • F-14: 1938: FS124000. 1939: FS139607. Final: FS155902.

Only 25 numbers (501–525) are listed for 1932, so a "1932 F-12" is rare. Check the number before believing it.

Worked example 1 (made-up number): a plate ahead of the gear shift, below the steering column, reads FS 52350. That's above the 1936 start (48660) and below the 1937 start (81837), so it's a 1936 F-12. It should have the low seat and steering wheel and govern near 1,400 rpm. If it has F-14 steering, those parts were added later.

Worked example 2 (made-up number): a tractor advertised as a "1938 F-14" has a plate above the clutch housing reading FS 141200. That's past the 1939 start (FS139607), so it's a 1939 F-14, from the last year of production.

What to check before you buy

  • Match the plate to the features. An F-12 number with F-14 steering, or the reverse, means swapped parts. That's common and not a dealbreaker, but it affects originality and price.
  • Engine type and condition. Confirm whether it's a Waukesha or an IH engine. With the ignition off, turn it over by the crank and feel for even compression on all four cylinders. Check the block and head for freeze cracks.
  • Fuel setup. Many of these were set up to start on gasoline and run on kerosene. Farm Collector's F-14 owner notes that kerosene left in the carburetor makes a cold start hard. Find out what's in each tank before you try it.
  • Gears. The three-speed isn't synchronized. Stop fully before shifting. If you haven't run one, read how an unsynchronized transmission works first.
  • PTO. Tractor Data lists a 1-1/8 in shaft for the F-12. Measure it before buying an implement for it.

Mistakes to avoid

  • Calling it an F-14 because of the steering. Steering and seat parts move between tractors. The serial plate decides.
  • Quoting F-14 power for an F-12. The F-14's higher rpm is where its extra power comes from. An F-12's figures are the ones from tests 212 and 220.
  • Ordering engine parts without checking the engine. An early F-12 may have a Waukesha, which is a different engine from IH's.
  • Starting it on kerosene from cold. Start on gasoline, and run the kerosene out of the carburetor on gasoline before shutting down so the next start is easy.
  • Wire-wheeling the serial plate. Clean it with solvent and a soft brush. The number is the tractor's identity.

The F-12's bigger sibling has its own guide: the Farmall F-20. For the styled tractors that followed, see the Farmall H.

More videos on this tractor

All Farmall & International Harvester tractor guides →