TribeCreek Subscribe on YouTube

Home › Ford & Fordson › 01 Series (1957–1962)

Ford 701 Series (1958–1962): Identifying a 741 or 771 Row-Crop Workmaster and What to Check

Updated November 21, 2026 · Sources are linked in the text

A tall red Ford with a narrow front end and a Workmaster emblem is most likely a 701 Series row-crop, and the stamping will almost always read 741 or 771. The difference between those two is the transmission: a plain four-speed in the 741, a Select-O-Speed power shift in the 771. That changes what the tractor is worth, what it costs to fix, and which parts fit.

This page covers what a 701 is, how to tell the 741 from the 771 and both from their look-alikes, how to date the serial, and what to check before buying one. It's the written companion to our video on the Ford 741 and 771.

Video: Ford 741 & 771 Tractors (1958–1962): History & Specs (3:17) · Watch on YouTube

What a 701 is

The 701 is the high-clearance row-crop tractor of Ford's 01 Series, introduced in late 1957 for 1958. The N Tractor Club groups it with the 501 and 601 as a Workmaster, with the 134 cu in gas or LP engine or the 144 cu in diesel, and decodes a first digit of 7 as "high clearance row crop" (N Tractor Club Quick ID guide). It replaced the Hundred Series 700, which Tractor Data lists only as the 740.

Tractor Data lists two models, both built 1958 to 1962 at Highland Park, Michigan:

7414-speed unsynchronized, transmission-driven 540 rpm PTO, three-point lift
771Select-O-Speed, 10 forward and 2 reverse, full power shift; live 540 rpm PTO; three-point lift

The N Tractor Club's chart reads a second digit of 4 as four-speed with PTO and lift, and 7 as Select-O-Speed with single-speed PTO and lift. Ford's numbering would allow other 7_1 combinations, but Tractor Data lists only these two. If a stamping reads something else, treat it as uncommon and check it against the tractor.

Front-end suffixes matter on a row-crop. The N Tractor Club lists -1 for a tricycle with a single front wheel, -4 for high clearance with a wide front, and -5 for a factory wide front. Fuel suffixes are -L for LP-gas and -D for diesel.

Specifications

Engine (gas or LP)Ford 134 cu in 4-cylinder, 3.4375 x 3.60 in bore and stroke, 7.5:1 compression (gas), 2,200 rpm
Engine (diesel)Ford 144 cu in 4-cylinder, 3.562 x 3.60 in, 2,200 rpm
Power (claimed)32 belt hp
Transmission4-speed (741); Select-O-Speed 10F/2R (771)
HydraulicsOpen center; Category I three-point with position and draft control (741), 1,250 lb lift
Electrical6-volt positive ground (gas and LP); 12-volt negative ground (diesel); 20-amp generator
Wheelbase / weight85.3 in / 3,400 lb
Ground clearance27.25 in
Rear tread56 to 80 in
Fuel tank13 gal

Figures from Tractor Data's 741, 741 engine, 741 dimensions, 771 and 771 transmission pages. Neither the 741 nor the 771 appears in the University of Nebraska's 1958–1963 Ford test listings (1958–1959; 1960–1963), so there are no tested figures. The 32 hp is Ford's claim. For reference, the same 134 engine in a 641 utility tested at 33.65 maximum belt hp in Nebraska Test 642 (Tractor Data), but that is a 641 result, not a 741 one.

Telling the 741 from the 771

Look at the shifter before anything else. The 741 has a conventional gear lever for a four-speed crash box. The 771's Select-O-Speed shifter looks nothing like a gear lever; the N Tractor Club guide pictures it beside a five-speed lever. Then confirm with the stamping's second digit: 4 or 7. The N Tractor Club dates the Select-O-Speed to 1959, so a 771 with a 1958 serial deserves a closer look.

Telling it from its siblings

From a Hundred Series 700. The 700 has a third digit of 0 and gas or LP only. Per the N Tractor Club, Workmasters have an all-red hood with gray only on the grille, fenders and wheels, a plastic hood emblem and restyled rear fenders. Tractor Data lists the same 85.3-inch wheelbase for the 740 and the 741, so don't use that to separate them.

From a 901 Powermaster. The 901 is the row-crop with the 172 engine. It has a red hood center with gray sides and an egg-crate grille. The block casting settles it: 310905, B9NN-6015C or CONN-6015C is a 134; B9NN-6015A is the 144 diesel; 310609, B9NN6015J or CONN-6015J is a 172 (N Tractor Club).

From a 601 utility. The 601 is low with a wide adjustable front. Tractor Data lists 74.5 inches of wheelbase for the 681 utility against 85.3 for the 741.

From a 541 offset. The 541 has its engine offset to the driver's left. The 741 is symmetrical.

Reading and dating the serial

The model and serial are on the left side, behind the starter, on top of the transmission case (Tractor Data), with the serial between two diamonds below the model number (N Tractor Club).

YearN Tractor ClubTractor Data (start)
195811,997–58,31111,977
195958,312–105,94258,312
1960105,943–131,426105,943
1961131,427–155,530131,427
1962155,531 and up155,531

My Ford Tractors matches the N Tractor Club through 1960. The 1957 range is in Decoding Ford 01 Series Model Numbers.

Worked example (made-up numbers): 771-4 over ◇138205◇.

  1. 7: high-clearance row-crop, Workmaster engine.
  2. 7: Select-O-Speed with single-speed PTO and lift.
  3. 1: 01 Series.
  4. -4: high clearance with a wide front.
  5. 138205 falls between 131,427 and 155,530: 1961.

Result: a 1961 Ford 771 with a high-clearance wide front. On the tractor you should see a Select-O-Speed shifter and a wide front axle, not a tricycle pedestal.

What to check before buying one

  • The front end. Jack up the front and rock each wheel for spindle and bearing play. On a tricycle, look for cracks or welds around the pedestal. Row-crop front parts are not shared with the 601.
  • The Select-O-Speed on a 771. Drive it through every range forward and reverse with a load. Slipping, delayed engagement or a dead range means transmission work.
  • The four-speed on a 741. It's unsynchronized, so stop to shift. Grinding at a standstill with the clutch fully down points to a dragging clutch. See how a crash-box transmission works.
  • The lift. Raise a heavy implement, shut down, and watch for settling over several minutes.
  • Oil condition. Look for coolant in the engine oil and water in the transmission and rear end.
  • Electrics. Gas and LP models left the factory 6-volt positive ground; diesels 12-volt negative ground. Check which you have before buying a battery.

Mistakes to avoid

  • Treating a tricycle like a wide front. A narrow front tips far more easily on side hills and in turns with a raised load.
  • Putting a heavy loader on a tricycle. It loads the pedestal and spindles hard and makes the tractor less stable.
  • Paying 771 money without checking the transmission. A Select-O-Speed that doesn't work properly can cost more to fix than the price difference.
  • Ordering front-end parts without the suffix. A -1, -4 and -5 have different front ends.
  • Dating it with the Hundred Series chart. The 01 Series restarted its serials, so the wrong chart gives the wrong year.

All Ford & Fordson tractor guides →